question and answer

You may ask technical questions here by leaving a comment. Authors of this side may pick up your questions and answer them as comments or as posts. Please do not leave personal information in the comment because the comment will be shown publicly.

Please share if you like this post:

7 comments:

  1. How to disable the locking file `~lock.filename.docx#` for LibreOffice? It causes quite some problems to my network mounted filesystems.

  2. How to test a path (a file or directory exists) in golang?

    In Bash, the [ -e ] tests can test whether a file or a directory exist. What are the corresponding Go ways for the test?

  3. How to test a path (a file or directory exists) in golang?

    In Bash, the [ -e ] tests can test whether a file or a directory exist. What are the corresponding Go ways for the test?

  4. How to install a HP printer 690C to make sure that I can enable the “Cleaning Cartridge” and “Calibrate Catridges” options ?

  5. Title: How to configure routing & iptables to separate the traffic by host IP.

    Good morning,
    I’ve a private network where I whould separate the traffic generated by a windows server 172.10.10.100 to different path.
    I can’t change server configuration. It’s possible only change the Gateway IP.

    The server will be connected to a linux device.
    I would forward the packets by IP. On linux device, on ethernet ports:
    2.0 there is the server 172.10.10.100/16
    2.1 there are some devices 172.10.1.61 … 77/16
    2.2 there are some devices 172.10.1.51 .. 54/16
    I would like pass through all protocols.

    Could you help me?
    Thanks in advace.

    1. 127.10.10.100 and 127.10.1.* are within the same network 127.10.*.*/16. The Linux device may not be forwarding packets and the Linux device may not have any effect.

      One possible way may be to change the Windows server IP and make the Linux device a gateway (ref https://www.systutorials.com/1372/setting-up-gateway-using-iptables-and-route-on-linux/ ) of the Windows Server. You need to change the IPs and network masks accordingly. Then the traffic will be to different ports for different IPs.

Leave a Reply

Your email address will not be published. Required fields are marked *