blkzone (8) - Linux Man Pages
blkzone: run zone command on a device
blkzone - run zone command on a device
SYNOPSISblkzone command [options] device
DESCRIPTIONblkzone is used to run zone command on device that support the Zoned Block Commands (ZBC) or Zoned-device ATA Commands (ZAC). The zones to operate on can be specified using the offset, count and length options.
reportThe command blkzone report is used to report device zone information.
By default, the command will report all zones from the start of the block device. Options may be used to modify this behavior, changing the starting zone or the size of the report, as explained below.
|start||Zone start sector|
|len||Zone length in number of sectors|
|wptr||Zone write pointer position|
|reset||Reset write pointer recommended|
|non-seq||Non-sequential write resources active|
|nw||Not write pointer|
|x?||Reserved conditions (should not be reported)|
resetThe command blkzone reset is used to reset one or more zones. Unlike sg_reset_wp(8), this command operates from the block layer and can reset a range of zones.
By default, the command will operate from the zone at device sector 0 and reset all zones. Options may be used to modify this behavior as well as specify the operation to be performed on the zone, as explained below.
OPTIONSThe offset and length option arguments may be followed by the multiplicative suffixes KiB (=1024), MiB (=1024*1024), and so on for GiB, TiB, PiB, EiB, ZiB and YiB (the "iB" is optional, e.g., "K" has the same meaning as "KiB") or the suffixes KB (=1000), MB (=1000*1000), and so on for GB, TB, PB, EB, ZB and YB. Additionally, the 0x prefix can be used to specify offset and length in hex.
- -o, --offset sector
- The starting zone specified as a sector offset. The provided offset in sector units (512 bytes) should match the start of a zone. The default value is zero.
- -l, --length sectors
- The maximum number of sectors the command should operate on. The default value is the number of sectors remaining after offset. This option cannot be used together with the option --count.
- -c, --count count
- The maximum number of zones the command should operate on. The default value is the number of zones starting from offset. This option cannot be used together with the option --length.
- -v, --verbose
- Display the number of zones returned in the report or the range of sectors reset..
- -V, --version
- Display version information and exit.
- -h, --help
- Display help text and exit.
Shaun Tancheff <shaun [at] tancheff.com> Karel Zak <kzak [at] redhat.com>
AVAILABILITYThe blkzone command is part of the util-linux package and is available from Linux Kernel Archive