SysTutorials

Linux Manual Pages › Section 8

rescan-scsi-bus-sh(8)

rescan-scsi-bus.sh – script for adding and removing SCSI devices without rebooting

Synopsis

rescan-scsi-bus.sh [options] [host [host …]]

Options

-a, –alltargets
scan all targets, not just currently existing [default: disabled]
-d
enable debug [default: 0]
-l
activates scanning for LUNs 0–7 [default: 0]
-L NUM
activates scanning for LUNs 0–NUM [default: 0]
-w, –wide
scan for target device IDs 0–15 [default: 0–7]
-c
enables scanning of channels 0 1 [default: 0 / all detected ones]
-r, –remove
enables removing of devices [default: disabled]
-f, –flush
flush failed multipath devices [default: disabled]
-i, –issue-lip
issue a FibreChannel LIP reset [default: disabled]
-m, –multipath
update multipath devices [default: disabled]
-u, –update
look for existing disks that have been remapped
-s, –resize
look for resized disks and reload associated multipath devices, if applicable
–forcerescan
rescan existing devices
–forceremove
remove and readd every device (DANGEROUS)
–nooptscan
don’t stop looking for LUNs if 0 is not found
–color
use coloured prefixes OLD/NEW/DEL
–hosts=LIST
scan only host(s) in LIST
–channels=LIST
scan only channel(s) in LIST
–ids=LIST
scan only target ID(s) in LIST
–luns=LIST
scan only lun(s) in LIST
–sync, –nosync
issue a sync / no sync [default: sync if remove]
–attachpq3
tell kernel to attach sg to LUN 0 that reports PQ=3
–reportlun2
tell kernel to try REPORT_LUN even on SCSI2 devices
–largelun
tell kernel to support LUNs > 7 even on SCSI2 devs
–sparselun
tell kernel to support sparse LUN numbering
Host numbers may thus be specified either directly on cmd line (deprecated) or or with the –hosts=LIST parameter (recommended).

LIST: A[-B][,C[-D]]… is a comma separated list of single values and ranges (No spaces allowed.)

See Also

rescan-scsi-bus.sh Homepage: http://www.garloff.de/kurt/linux/#rescan-scsi sg3_utils Homepage: http://sg.danny.cz/sg