mbtowc (3p) - Linux Man Pages
mbtowc: convert a character to a wide-character code
PROLOGThis manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
mbtowc - convert a character to a wide-character code
If s is not a null pointer, mbtowc() shall determine the number of bytes that constitute the character pointed to by s. It shall then determine the wide-character code for the value of type wchar_t that corresponds to that character. (The value of the wide-character code corresponding to the null byte is 0.) If the character is valid and pwc is not a null pointer, mbtowc() shall store the wide-character code in the object pointed to by pwc.
The behavior of this function is affected by the LC_CTYPE category of the current locale. For a state-dependent encoding, this function is placed into its initial state by a call for which its character pointer argument, s, is a null pointer. Subsequent calls with s as other than a null pointer shall cause the internal state of the function to be altered as necessary. A call with s as a null pointer shall cause this function to return a non-zero value if encodings have state dependency, and 0 otherwise. If the implementation employs special bytes to change the shift state, these bytes shall not produce separate wide-character codes, but shall be grouped with an adjacent character. Changing the LC_CTYPE category causes the shift state of this function to be unspecified. At most n bytes of the array pointed to by s shall be examined.
If s is a null pointer, mbtowc() shall return a non-zero or 0 value, if character encodings, respectively, do or do not have state-dependent encodings. If s is not a null pointer, mbtowc() shall either return 0 (if s points to the null byte), or return the number of bytes that constitute the converted character (if the next n or fewer bytes form a valid character), or return -1 and may set errno to indicate the error (if they do not form a valid character).
The mbtowc() function may fail if:
Invalid character sequence is detected.
COPYRIGHTPortions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .
Linux man pages generated by: SysTutorials