strsignal (3p) - Linux Manuals

strsignal: get name of signal


This manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.


strsignal --- get name of signal


#include <string.h>

char *strsignal(int signum);


The strsignal() function shall map the signal number in signum to an implementation-defined string and shall return a pointer to it. It shall use the same set of messages as the psignal() function.

The application shall not modify the string returned. The returned pointer might be invalidated or the string content might be overwritten by a subsequent call to strsignal() or setlocale().

The contents of the message strings returned by strsignal() should be determined by the setting of the LC_MESSAGES category in the current locale.

The implementation shall behave as if no function defined in this standard calls strsignal().

Since no return value is reserved to indicate an error, an application wishing to check for error situations should set errno to 0, then call strsignal(), then check errno.

The strsignal() function need not be thread-safe.


Upon successful completion, strsignal() shall return a pointer to a string. Otherwise, if signum is not a valid signal number, the return value is unspecified.


No errors are defined.

The following sections are informative.






If signum is not a valid signal number, some implementations return NULL, while for others the strsignal() function returns a pointer to a string containing an unspecified message denoting an unknown signal. POSIX.1-2008 leaves this return value unspecified.




Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2013 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 7, Copyright (C) 2013 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. (This is POSIX.1-2008 with the 2013 Technical Corrigendum 1 applied.) In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at .

Any typographical or formatting errors that appear in this page are most likely to have been introduced during the conversion of the source files to man page format. To report such errors, see .


psiginfo(), setlocale()

The Base Definitions volume of POSIX.1-2008, <string.h>