sane-sm3840 (5) - Linux Manuals
sane-sm3840: SANE backend for Microtek scanners with SCAN08 USB chip
sane-sm3840 - SANE backend for Microtek scanners with SCAN08 USB chip
DESCRIPTIONThe sane-sm3840 library implements a SANE (Scanner Access Now Easy) backend that provides access to some Microtek scanners with the SCAN08 USB chip.
There also exists a Microtek 3600 series driver, see sane-sm3600(5) for details.
At present, the following scanners are known positively to work with this backend:
Vendor Product ID: Remark: -------- -------------- ----------- Microtek ScanMaker 3840 All modes OK Microtek ScanMaker 4800 All modes OK
If you own a Microtek scanner with the SCAN08 chip other than the ones listed above, it may or may not work with SANE. Feel free to contact the backend author (earle [at] ziplabel.com) to report results with scanners not on the list.
The following options are supported by the sane-sm3840 driver:
- --mode color|gray|lineart|halftone
Color or grayscale mode.
- --resolution 150|300|600|1200
Pixels per inch for scans.
- --depth 8|16
Note that the least significant bits of 16bpp mode may be noise.
- --brightness 1..4096
Higher numbers increase brightness of returned image.
- --contrast 0.1..9.9
Larger numbers decrease contrast of returned image.
- --lamp-timeout 1..15
Time in minutes until the lamp is turned off after a scan.
CONFIGURATIONThis backend does not support a configuration file right now.
- The static library implementing this backend.
The shared library implementing this backend (present on systems that
support dynamic loading).
If the library was compiled with debug support enabled, this
environment variable controls the debug level for this backend. E.g.,
a value of 128 requests all debug output to be printed. Smaller
levels reduce verbosity. To see error messages on stderr set
AUTHOREarle F. Philhower III <earle [at] ziplabel.com>
SEE ALSOsane(7), sane-microtek(5), sane-microtek2(5), sane-sm3600(5)