sg_rmsn (8) - Linux Man Pages
sg_rmsn: send SCSI READ MEDIA SERIAL NUMBER command
NAMEsg_rmsn - send SCSI READ MEDIA SERIAL NUMBER command
SYNOPSISsg_rmsn [--help] [--raw] [--readonly] [--verbose] [--version] DEVICE
Send a SCSI READ MEDIA SERIAL NUMBER command to DEVICE and outputs the response.
This command is described in SPC-3 found at www.t10.org . It was originally added to SPC-3 in revision 11 (2003/2/12). It is not an mandatory command and the author has not seen any SCSI devices that support it.
OPTIONSArguments to long options are mandatory for short options as well.
- -h, --help
- output the usage message then exit.
- -r, --raw
- sends the serial number (if found) to stdout. This output may contain non-printable characters (e.g. the serial number is padded with NULLs at the end so its length is a multiple of 4). The default action is to print the serial number out in ASCII-HEX with ASCII characters to the right. All error messages are sent to stderr.
- -R, --readonly
- opens the DEVICE read-only rather than read-write which is the default. The Linux sg driver needs read-write access for the SCSI READ MEDIA SERIAL NUMBER command but other access methods may require read-only access.
- -v, --verbose
- increase the level of verbosity, (i.e. debug output).
- -V, --version
- print the version string and then exit.
NOTESDevice identification information is also found in a standard INQUIRY response and its VPD pages (see sg_vpd). The relevant VPD pages are the "device identification page" (VPD page 0x83) and the "unit serial number" page (VPD page 0x80).
EXIT STATUSThe exit status of sg_rmsn is 0 when it is successful. Otherwise see the sg3_utils(8) man page.
AUTHORSWritten by Douglas Gilbert.
REPORTING BUGSReport bugs to <dgilbert at interlog dot com>.
COPYRIGHTCopyright © 2005-2012 Douglas Gilbert
This software is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
SEE ALSOsg_vpd(sg3_utils), sg_get_config(sg3_utils)