daylight (3p) - Linux Manuals
daylight: set timezone conversion information
PROLOGThis manual page is part of the POSIX Programmer's Manual. The Linux implementation of this interface may differ (consult the corresponding Linux manual page for details of Linux behavior), or the interface may not be implemented on Linux.
daylight, timezone, tzname, tzset - set timezone conversion information
extern int daylight;
extern long timezone;
The tzset() function shall use the value of the environment variable TZ to set time conversion information used by ctime(), localtime(), mktime(), and strftime() . If TZ is absent from the environment, implementation-defined default timezone information shall be used.
The tzset() function shall set the external variable tzname as follows:
tzname = "std"; tzname = "dst";
where std and dst are as described in the Base Definitions volume of IEEE Std 1003.1-2001, Chapter 8, Environment Variables.
The tzset() function also shall set the external variable daylight to 0 if Daylight Savings Time conversions should never be applied for the timezone in use; otherwise, non-zero. The external variable timezone shall be set to the difference, in seconds, between Coordinated Universal Time (UTC) and local standard time.
No errors are defined.
Example TZ variables and their timezone differences are given in the table below:
COPYRIGHTPortions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .