amtape (8) - Linux Man Pages
amtape: Control Amanda changers
amtape - Control Amanda changers
configoption...] config subcommand [subcommand_options...]
Tape changers maintain a notion of the current slot for each configuration. This may or may not correspond to an actual physical state of the device, but is used by some taperscan algorithms to minimize searching through the slots.
- Search for and load the Amanda tape with label [label], also setting the current slot.
- Load the volume in the given slot, also setting the current slot. The slot names current, next, first, and last have special meaning.
- Shorthand for slot current.
- Show the contents of all slots, based on the changer's cached metadata. This is a quick operation as it does not load or unload any volumes, but is not supported by all changers.
- Show the contents of all slots (or listed slots) by loading each slot and reading its label. This can be very slow. The slots arguments is of the form 1,3-5,7.
- Reset the changer to a known state. This subcommand is intended to clear any unknown and potentially incorrect state the changer may have stored.
- Eject the tape currently in the drive. This only applies to some changers. Specify a drive (by drive number) if more than one drive is available.
- If a cleaning tape is defined for the changer, used it to clean the specified drive. The [drive] is optional if the changer only has one drive.
- Run the taperscan algorithm (see amanda-taperscan(7)), displaying information about the progress of the scan.
- Update changer state. Consult amanda-changers(7) for changer-specific details on the format of what.
- See the "CONFIGURATION OVERRIDE" section in amanda(8).
Dustin J. Mitchell <dustin [at] zmanda.com>
- Zmanda, Inc. (http://www.zmanda.com)
James da Silva <jds [at] amanda.org>
Stefan G. Weichinger <sgw [at] amanda.org>