smp_rep_phy_sata (8) - Linux Man Pages
smp_rep_phy_sata: invoke REPORT PHY SATA SMP function
NAMEsmp_rep_phy_sata - invoke REPORT PHY SATA SMP function
SYNOPSISsmp_rep_phy_sata [--affiliation=AC] [--help] [--hex] [--interface=PARAMS] [--phy=ID] [--raw] [--sa=SAS_ADDR] [--verbose] [--version] [--zero] SMP_DEVICE[,N]
Sends a SAS Serial Management Protocol (SMP) REPORT PHY SATA request function to an SMP target. The SMP target is identified by the SMP_DEVICE and the SAS_ADDR. Depending on the interface, the SAS_ADDR may be deduced from the SMP_DEVICE. The mpt interface uses SMP_DEVICE to identify an HBA (an SMP initiator) and needs the additional ,N to differentiate between HBAs if there are multiple present.
- -a, --affiliation=AC
- where AC is the affiliation context relative identifier that is placed in request (new in sas2r08). Defaults to 0.
- -h, --help
- output the usage message then exit.
- -H, --hex
- output the response (less the CRC field) in hexadecimal.
- -I, --interface=PARAMS
- interface specific parameters. In this case "interface" refers to the path through the operating system to the SMP initiator. See the smp_utils man page for more information.
- -p, --phy=ID
- phy identifier. ID is a value between 0 and 254. Default is 0.
- -r, --raw
- send the response (less the CRC field) to stdout in binary. All error messages are sent to stderr.
- -s, --sa=SAS_ADDR
- specifies the SAS address of the SMP target device. Typically this is an expander. This option may not be needed if the SMP_DEVICE has the target's SAS address within it. The SAS_ADDR is in decimal but most SAS addresses are shown in hexadecimal. To give a number in hexadecimal either prefix it with '0x' or put a trailing 'h' on it.
- -v, --verbose
- increase the verbosity of the output. Can be used multiple times
- -V, --version
- print the version string and then exit.
- -z, --zero
- zero the Allocated Response Length field in the request. This option also zeros the Request Length field in the request. This is required for strict SAS-1.1 compliance. However this option should not be given in SAS-2 and later; if it is given an abridged response may result.
EXAMPLESSee "Examples" section in http://sg.danny.cz/sg/smp_utils.html
CONFORMING TOThe SMP REPORT PHY SATA function was introduced in SAS-1 . The "Expander change count", "STP I_T nexus loss occurred" and several other fields were added in SAS-2 .
AUTHORSWritten by Douglas Gilbert.
REPORTING BUGSReport bugs to <dgilbert at interlog dot com>.
COPYRIGHTCopyright © 2006-2011 Douglas Gilbert
This software is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
SEE ALSOsmp_utils, smp_phy_control(smp_utils)