i3-wsbar (1) Linux Manual Page
i3-wsbar – sample implementation of a standalone workspace bar
Synopsis
i3-wsbar -c <dzen2-commandline> [options]Options
- –command <command>
- This command (at the moment only dzen2 is supported) will be started for each output. %x will be replaced with the X coordinate of the output.
Example:
–command “dzen2 -dock -x %x”
- –input-on <list-of-RandR-outputs>
- Specifies on which outputs the contents of stdin should be appended to the workspace bar.
Example:
–input-on “LVDS1”
- –output-on <list-of-RandR-outputs>
- Specifies for which outputs i3-wsbar should start "command".
- –show-all
- If enabled, all workspaces are shown (not only those of the current output). Handy to use with "–output-on".
- –input-on <list-of-RandR-outputs>