Wimax_reset (9) Linux Manual Page

wimax_reset – Reset a WiMAX device

Synopsis

int wimax_reset(struct wimax_dev *wimax_dev);

wimax_dev

WiMAX device descriptor

0 if ok and a warm reset was done (the device still exists in the system).

–ENODEV if a cold/bus reset had to be done (device has disconnected and reconnected, so current handle is not valid any more).

–EINVAL if the device is not even registered.

Any other negative error code shall be considered as non-recoverable.

Called when wanting to reset the device for any reason. Device is taken back to power on status.

This call blocks; on successful return, the device has completed the reset process and is ready to operate.